Talosaga Talosaga

is used to directly measure the oxygen content in various metallurgical heating furnaces, stepping heating furnaces, energy storage heating furnaces, stainless steel bright annealing furnaces and ceramic tunnel sintering furnaces. O le faʻaaogaina o le kesi o le vevela o le kesi o loʻo i le laina o le 0 ° C ~ 1200 ° C, ma le puipuiga o le pito i fafo o le maualuga-vevela.

^-30

•Faʻataʻitaʻiga

•Atigi mea

•

•Vevela pulea

•Lerumocouple

•

•Faapipiiina ma sootaga: O le Probe e sau ma 1.5 "BSP po o le NPTS TONI. O le tagata faʻaoga e mafai ona faʻagaioi le tutusa o le flating o le ogaumu e tusa ai ma le faʻapipiʻi ata i le tusi lesona.

• 

•Kesi kesi

•: The sensor has an air inlet that can pass check gas. When it is not checked, it is closed by a bulkhead. When calibrating the air, the flow rate is controlled at about 1000 ml per minute. O le tagata gaosi oloa saunia 1/8 "NPTS TOTONU PING SINIDS e mafai ona fesoʻotaʻi i PVC paipa.

•: 4-6 tausaga o le faifai pea taotoga. E faʻalagolago i le faʻapoloka kesi ma le vevela. Intermittent operation will affect the service life, and the heater should be kept running continuously.

•Tali Atu Taimi

• Faamama

• Probe puipuia le TRUB TIBE PEROER

•:

•

• Mamafa: 1.5kg Plus 0.55KG / 100mm umi.

•Calibration

•Umi: